Where is everyone?

[donram360]

And the trans turned out alright in my Dakota without costing a grand like the last 2 that I took in for "bench" rebuilds did
Though one of those was a Ford trans, of which I know nothing about their innards like I do these units

[magnumman]

Huh I would figure that this site would be busier with all of the covid crap along with the shelter in place going on these days
I have this week off because of it, I know I'm spending alot of it in the garage.

There has been a ton of google visitors, they research their problem, it brings them here for their answer.  Then they leave and don't sign up.

[TenneSS/T]

I rarely get on forums anymore.  It seems they are all dead.  I still have all my rides.  I did pick up a brand new 2019 Challenger 392 T/A for a used car price.
156072CA-B3D5-42E9-BDE4-DF0100C89D5F by Kevin Isenberg, on Flickr

[magnumman]

Nice rides TenneSS/T.  Good to see ya.

[donram360]

Putting a dorman (yeah Chinese but I didn't buy it, the truck's owner did) stainless steel brake lines kit on a rusty Chevy truck, then discovered that the back brakes were shot and haven't worked in forever, pads seized in caliper brackets. Had to also replace backing plates, (splash shields) as they were almost non-existent, plus Ebrake shoes since lining had disintegrated due to age and rust/ had to bead blast caliper brackets, and caliper bracket mount piece to get the fragments of what was left of the splash shields so everything sat flush and square again... Should have just replaced the rear end cover because of the time spent factor, I put that in my bead blast cabinet too. Waiting for the primer to dry on that.